Troubleshooting EV3 and MakeCode

I am a big fan of Lego Mindstorms and MakeCode. However, the firmware is a bit buggie. The main issues that I have had is that after a while, the EV3 drive does not map and no amount of restarts seem to fix it. The other is that there must be an issue with adding programs with the same filenames or something. Certainly, you can’t delete from the brick. This means that when you tweak a setting and upload your program again, the old version runs and not the new. Given the rate of prototyping cycles involved in Robotics, I hope they solve this one soon. Some guidance to solve these issues is below.

TROUBLESHOOTING-EV3-WITH-MAKECODE

Leave a Reply